1. Be prepared
Gather and purchase all of the supplies necessary to complete
your sewing or craft project ahead of time. Having to stop in the middle of the
project in order to run out and get a forgotten essential item is time consuming
2. Check the threading of your
Double check the threading of your sewing machine to prevent
immediate stitching problems. Breaking thread or skipped stitches right off the
bat can cause you to lose interest in the project, not to mention the time lost
in fixing the problem. And speaking of thread, always use a good quality thread.
"Cheap" thread will fray, break and cause knotting of the thread while
3. Use the correct needles for the
It is a mistake to simply use the same needle for everything
you sew until it breaks. Some fabrics require a fine needle while heavier duck
type or denim fabrics require a heavier needle. Keep a supply of assorted
machine needles handy so you'll have the correct needle for the fabric you'll be
using. In addition, if you hit a pin, you should immediately change the needle.
A bent needle, even if only "slightly" bent or nicked can cause
skipped stitches and can quite possibly cause damage to your fabric.
4. Cut the fabric carefully
All pattern pieces have grain line markings. The grain line
should run parallel with the length of the fabric. If you simply lay the pattern
pieces anywhere on the fabric, ignoring the grain- lines, the finished garment
will not hang right. The extra few minutes spent laying the pattern pieces
correctly and cutting the seam lines precisely will result in a professional
looking garment you will be proud of.
5. Practice unusual or new
If your project or garment includes a technique you are not
familiar with, or haven't done in quite some time, such as buttonholes or flat
felled seams, practice on a piece of extra fabric. It would be best to make two
or three practice samples before actually sewing on the garment itself.
6. Clip all threads as you sew
It only takes a second to clip the stitches from the
beginning and end of the seams. If you wait until the garment is finished it
will become a chore and you may be tempted to leave them, resulting in an
unprofessional looking garment. Be sure to have a waste basket handy, or tape a
small lunch bag to the side of your sewing machine table in which to toss the
threads after clipping.
7. Press seams as you work
Pressing the seams during the sewing process will produce a
more professional looking garment, and will also make it easier to sew the seams
that will "cross" any of the seams already sewn. Gently open the seams
and press flat. You will save time if you sew several seams, then press them all
at once, before moving on to the next step.
8. Clean the sewing area
Clean up the sewing area after each project. A great motto
for your sewing/craft area is "a place for everything and everything in
its' place". Put things away - left over fabric in a scrap box or drawer,
scissors, pins and thread back in the drawer. The sewing room will look much
better and an organized sewing area is much more inviting than a messy, piled up
area with only a "path" to the sewing machine.
About the author:
Sarah J. Doyle is author of over 25 sewing, craft and how-to
books, as well as author of online pattern making, sewing and craft classes.
for information on books, classes, newsletters and the latest hints and tips.
(c) Copyright 2003, Sarah J. Doyle. All Rights Reserved.